3 in 1 Diamond Microdermabrasion Dermabrasion Machine Facial Care Skin Equipment Water Spray Exfoliation Beauty Machine For Removal Wrinkle

 Function:

 ★ This Diamond Microdermabrasion machine refines, rejuvenates and smoothens skin.

 ★ It has 3 built-in functions --Diamond Microdermabrasion Therapy, Vacuum Therapy, and Spray function, and definitely a must-have equipment for aestheticians, dermatologists, or other clinical professionals - great for professional use and home use as well.

 ①  Diamond Dermabrasion

 Diamond Microdermabrasion provides a Non-Surgical skin resurfacing procedure by using sterile diamond heads to peel and rub off the dead cells at the top skin layer followed by vacuuming/suction removing particles along with any dirt and dead skin.This procedure removes skin debris, scars, blemishes, wrinkles and uneven pigmentation of the skin.

 ② Vacuum

 Vacuum Therapy Cleans dirty pores through suctioning tubes and increases blood circulation in the skin.

 Helps give elasticity in the skin and can decrease discoloration from acne and scars.

 There are three hose, they have the same function, you can choose any one to connect with the glass tube as you like.

 ③ Spray

 The Spray Function Refreshing mist used after a treatment. You should fill 1/2 to 3/4 of the bottle with toner and push the top of the bottle with your finger to create a mist spray. It helps closing pores and soothing the skin. This is usually done after diamond microdermabrasion peeling and vacuum suctioning. Also calming down the skin after peeling and suctioning. The skin is sensitive after peeling and vacuum treatment, so the spray procedure is necessary.

 Package List: 

    Diamond Dermabrasion Machine x1

    PVC vacuum hose 8*5x1

    Diamond Wands x3

    Diamond Tips x9

    Heads box & foam x1

    O-rings x3

    Cotton Filter x 2 package

    Power cord x1

    Fuse x3

    Manual x1

    Spray Bottle x 2

    Glass Tubes x 3

 Operating instruction:

 1. Push in the movable ring of copper nozzle at the hand piece, and pull out the 8x5 size vacuum hose. Then push in the black plastic ring on the vacuum hose.

 2. Put a drop of cream or milk lotion on the vacuum hose nozzle, push in the moveable ring and insert in the vacuum hose to the limit.

 3. Insert a cotton swab into the Diamond Head, then tight up the Diamond Head on the hand piece. Remove the cotton swab after every treatment.

 4. Turn on the power switch.

 5. Adjust the Vacuum intensity by Vacuum Regulator according to the reference table, the intensity displays on vacuum gauge and check for comfort.

 6. Use the incline area of Hand piece to contact with the skin surface. Proceed with a slow sliding motion. Do not place the hand piece at one spot for too long, doing this will cause harm to the skin.

 7. Adjust the crystal flow rate by Vacuum Regulator slowly from minimum to maximum. For common use, don\'t set the flow rate to maximum unless it is of necessity. This is better comfort intensity.

 8. Gently stretch the skin with thumb and finger, and glide the Hand-piece 2 to 3 times over the area being treated.

 Then cross again in different directions to prevent streaking lines as in the reference picture. Brush strokes or prevent streaking lines as in the reference picture. Brush strokes or polishing motions may be used in different sites.

 9. After treatment, brush off all remaining dead skin with a soft brush and rinse with damp sponges or damp cool towel.

 10. Allow skin to dry then apply desired skin product.

 11. To clean the Diamond Head, use toothbrush or cotton swab damped with a little alcohol to wipe off the dirty impurity, and then use UV light or high temperature for sterilization.