1. Vehicle Fitment: Engine computer board is replacement for Kia‑MEG17.9.12.1, which is made according to the prototype model.    

2. OEM Number: ECU electronic control unit replace part number is 39110 03420, 3911003420. Please make sure the OEM number matches the part you are replacing.    

3. Performance: Control unit is made of durable aluminum alloy housing and welded internal circuit boards to effectively prevent vibration and wear.    

4. Stable Characteristics: Professional manufacturing, high accuracy, stable characteristics and high reliability, practical for use.    

5. Upgraded Design: This module requires programming or special setup procedures. Manufactured to standard specifications to ensure powerful functionality.    

    Specification:

Item Type: Engine Computer Board    

Material: Aluminum alloy and ABS    

OEM Number: 39110 03420, 3911003420    

Application:    

Replacement for Kia‑MEG17.9.12.1    

Installation Precautions:    

1. It is recommended to find a professional auto mechanic to install the    

2. Product installation to pay attention to, first check out the reasons for the previous computer board bad, to avoid using the same fault again burned computer board. .    

3. Before installing the computer board to check whether the voltage is normal (voltage of about 12V), more than 15V recommended not to install, check whether the line is normal, the overlap is good, otherwise there is the possibility of burning the computer board.    

4. After the installation of the computer board (insert the plug for trial operation) key to NO position switch back and forth three or four times and then start.     

5. If the car has with anti-theft, you need to decode (match) before you can, this depends on your car rather than the computer board.    

The Correct Installation Method of the Computer Board:    

1. First remove the battery line a firewire, and then the computer board (circuit board) to install, and then connect the line.    

2. After the car key to NO on the car do not start, wait 1-2 minutes, and then ignition.    

3. If the last time you can not fire, and then repeat the previous step, try again, or look at the computer board and the computer board plug whether there is dust inside, if there is a clean brush to clean up, or check whether the pins are neat, so that the computer board installed on is basically OK.    

Common Fault Problem Solving Methods:    

1 Fault light indicates that there is a problem with the sensor.    

2 Repeatedly burn the computer board "ECU" or refueling does not work, please check whether the generator voltage is normal.    

3 Appear lack of cylinders, check the spark plug, ignition wire, injector nozzle, etc. is normal.    

4 Idle speed is unstable, please check whether the idle speed motor and throttle valve body are normal and there are foreign objects.    

5 If there is difficulty in starting, please check whether the pressure sensor and water temperature sensor are normal.    

6 If you cannot start, please check whether the crankshaft position sensor and speed sensor are normal.    

Basic Knowledge of Circuit Board:    

1 Product Installation: Confirm that the product model and specifications are normal, install and fix the new circuit board, connect the wiring harness connector, repeatedly switch the ignition switch 3-5 times "switch time 2-3 wonderful, off time 4-6 wonderful    

2 Check and Judgment After Installation: Whether the idle speed is running normally "hot 800-950 rpm, cold 1000-1300 rpm", whether the electronic fan is running normally "85.C on, 90.C off", whether the air conditioning is running normally "open the idle speed to 1100-1300 rpm", whether the hot engine exhaust is normal "if not normal, please check the pressure sensor", if there is idle speed, please adjust the ignition angle properly.    

    Package List:

1 x Engine Computer Board